Linking the Remotes

To link a Remote to a deck, place it into the dock and long press the corresponding setup button (A or B).

Two LED animations will indicate you successfully completed steps to link your Remotes. First, when long-pressing the setup buttons A or B to link a Remote, the Remote’s LED will flash for a couple seconds and will stop shortly after. If the color of the Remote’s LED strip and its setup button is the same, it means the Remote has been properly linked to the A or B channel: it is connected and communicating with that specific deck. 

When you take the Remote out of the Phase Receiver, the setup button will turn white, and the Remote’s LED will maintain its color. This behavior is correct: the button is always white when the dock is empty. 

If you disconnect a Remote by linking another one to the same deck of the Phase Receiver, the current linked Remote’s LED strip will briefly red flash and will turn white. This means the Remote has been disconnected from the deck it was linked to. A white LED color on any Remote indicates that said Remote is not linked to a Phase Receiver. 

Click the button below to discover the next feature.