Power and LED check

In this first step, we're going to make sure the Receiver is functioning by turning it on. 

Plug the USB cable to a power source then to the Receiver

Use the MWM USB cable to plug the Phase Receiver to a power outlet. Do not plug it in a computer yet, but use a power brick charger delivering 5V/500mA instead. The Receiver should turn on.

Several LED indicators will let you know the Phase is on and functional at this point.

• On the back of the Receiver, the lightning icon above the USB port, and the A and B indicators above the RCA connectors will light up. 

• On the Receiver’s front, the setup buttons of each deck (A and B) and the bottom five white dots will light up.

If the Receiver doesn't turn on, click here.

If your Phase Receiver turns on and its LEDs are lit up as described, click on the "Next" button below to proceed to the next step.