Activating the Pause mode (disabled for Serato DJ Pro USB integration)

You can activate the pause mode to emulate the tonearm being removed from the vinyl, and to stop the signal from being sent to your mixer.

It is activated by pressing one of the setup buttons. Both the LED strip on the Remote and the corresponding setup button will slightly flash. This not only means the Remote has been paused, but it also proves that the radio communication between the Remote and the Receiver is working well.

Additionally, the LEDs “A” and/or “B” at the back of the Phase Receiver will flash as well when pause mode is enabled. This will inform you that the communication has been suspended with that specific deck. To disable pause mode, simply press the corresponding setup button again. 

Please note that this feature is disabled when using Phase with Serato via HID (WIR deck mode). The signal will not be cut, but the LED will still blink if the button is short-pressed.

You reached the end of the Phase features guide, click here to go back to the Phase Help Center homepage.