Calibrating the Remotes
Before using the Remotes, their internal sensors have to be calibrated. For proper calibration, the Remotes should be placed on a flat and still surface. The LED strip will move up and down indicating the sensors inside the Remotes are calibrating. As these are motion sensors, it is very important to keep the Remotes motionless as long as the LEDs go back and forth. This will allow the sensors to find the zero point, and thus ensure the best accuracy when spinning the Remotes.
It takes a few seconds for the LED strip to fill up, which means the Remotes are ready to be used. Do not move the Remote as long as the LED is animated.
⚠️ Please note that the "Manual calibration" feature is different from the mandatory calibration step explained above. It is optional and is only useful if you notice a difference between your turntable's pitch and the pitch value displayed on the software decks.
Click the button below to discover the last feature.